This post will guide you on how to perform a software update for your Xtruck Y006 Nitrogen and Oxygen Sensor.
Step 1: Connect the device and update the program
1. Please connect the device to the computer through the USB interface, as shown below:
After a successful connection, press the "return" button to enter the update mode. If the screen displays "Update mode", it means that it has successfully entered the update mode.
Step 2: Install the CH340 serial driver
Open the CyberPower Disc Creator of the Nitrogen and Oxygen Sensor program, and click NOxProgramUpdate.
Find the file directory and click the SETUP.EXE file below, just as shown below:
NOxProgram Update
Re-open the Cyber Power Disc Creator “NOxProgramUpdate” of the nitrogen and oxygen sensor program.
Install the CH340 driver, just as shown below:
Click the Install button, and the interface as shown in the figure will pop up, and just wait for the installation.
If the connection status shows connected (as shown below), click the button to update the main program.
Wait for the update, if the following pop-up window is displayed, it means that the program update is successful.
No comments:
Post a Comment